LEXMARK 4408-EK1 DRIVER DOWNLOAD

How satisfied are you with this reply? The manufacturer is not responsible for safety in the event of use of unauthorized replacement parts. The LCD is on and operating. Jeeped Replied on February 19, Remove two screws E and remove two retainers.

Uploader: Shasida
Date Added: 10 March 2015
File Size: 69.24 Mb
Operating Systems: Windows NT/2000/XP/2003/2003/7/8/10 MacOS 10/X
Downloads: 68602
Price: Free* [*Free Regsitration Required]

Sorry this didn’t help. Unscrew and disconnect ground cable C.

If an incoming call is present and: Remove four screws A and remove fax card. Wipes the printhead nozzles to clean them of dirt.

If connected, check for approximately 30 volts on Carrier Transport pins 1 and 2 or at the wire connections 44088-ek1 on Motor the rear of the transport carrier motor.

Check all connections and plug Paper Feed Motor in the printer. Remove five screws A from the system board. Page 50 XXX 6.

I have a lexmark printer how do I get driver for download – Microsoft Community

Remove carrier shaft retainer clips A. Seals the printhead when it is not being used to prevent the nozzles from drying. Page 4 XXX Exit tray removal Remove three screws A from the rear cover.

  GATEWAY 838GM ETHERNET CONTROLLER DRIVER DOWNLOAD

Lexmark interact all-in-one printer quick reference guide 25 pages. Page 55 XXX 8. Slide maintenance station forward and remove. Preventive Maintenance XXX 6. Routing of all cables and orientation of scanner support springs. Disconnect media sensor J3 A.

Lift and remove ADF. Lexmark and Lexmark with diamond design are trademarks of Lexmark International, Inc. Page 35 Alignment Uneven vertical lines can be adjusted by performing the printhead alignment adjustments. Special tools and test equipment are listed in this chapter, as well as general environmental and safety instructions.

Remove two screws A from right cover. Page 46 XXX There should be no breaks in the nozzle test pattern.

I have a lexmark 4408 printer how do I get driver for download

Got it, continue to print. The alignment can also be performed from the control panel by selecting the Maintenance Option, then Align Cartridges. If your machine does have a paper jam problem, examine it for the following before you begin the service check: The LCD is on and operating. Flag and Spring Paper path service check Examine the machine for the following before you begin this service check: Diagnostic Aids XXX 3.

  FASTTRAK TX2650 LINUX DRIVER

Don’t show me this message again. Table of Contents Add to my manuals Add. Depress two clips A.

Disconnect all cables B from the system board.